Earlier this month I decided to put my IC-7610 aside and give the FTDX10 a good go in a contest. It was Oceania DX Contest and I opted to run SO 20m HP category. 24 hours of CW madness.

Conditions were excellent, but not as good as in SSB leg a week earlier.

One thing I love about this radio is how good its receiver is. The roofing filters did a great job, 300 Hz is amazing, albeit a bit too narrow for contest when running CQ. Too many stations tend to be off-beat a bit and the 500-600 Hz width works best for me.

I was able to hear weak stations quite easily right next to big ones and only once I had to ask someone to QSY as the station came too close, within 100 Hz of my frequency.

Talking about the off-beat stations, I had to use the Clarifier (RIT) quite a bit to pick them. I never liked the way the RIT is implemented on this radio. The CLAR RX and TX buttons are in the right place, but using the MPVD ring (multi purpose VFO outer dial) is not a good idea. A few times in contest the CLAR RX was off and moving the MPVD moved me way off my frequency. Very frustrating.

Read More

To operate CW with FTDX10 via USB using N1MM logger you need to install the virtual COM drivers, change radio settings and configure N1MM.

Virtual COM port drivers

To install virtual COM port drivers follow instructions here .  You can download drivers here.

Change radio settings

On your FTDX10 press the FUNC knob, select CW settings, select MODE CW and under PC Keying select RTS.

Press Back to exit this menu, then select Operation Settings, select General then select the CAT rate (mine is 4800). This value must be selected in the N1MM settings (below).

Read More